18mm Gear box shaft??!?

Status
Not open for further replies.

Fallenleopard

New member
Messages
194
Reaction score
2
Location
N.S.W Australia
Ok so I was about to go and buy a sprocket for my gear box (just has a shalf with keyway) and after measuring it, I've realised it's a 18mm shaft. What options do I have? I don't have access to a lathe to bore out a smaller one. Would a 19mm sprocket dot or be too big. I need a sprocket on this shaft only about 12T

Thanks

Sent from my SM-G930F using Tapatalk
 

itsid

Moderator
Staff member
Messages
11,563
Reaction score
261
Location
Ruhrpott [Germany]
:useless: I'm afraid.

no you can't just mount a bigger bore sprocket..
with a 0.5mm shim perhaps.. but only if it's a wide enough hub on the sprocket, and it's keyed bore and shaft.

post pics please

'sid
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
Guys, please remember, OP is Aussie...

Probably the best advice I can offer is find an industrial supplies (like International Bearing Supplies, CBC) who should have a range of sprockets; unfortunately, they will have a 10mm centre bore, which will need to be machined out to the correct size & have a keyway cut...

I see no reason why you couldn't use a 0.5mm shim on a 19mm bore sprocket...

As a last resort, search ebay, you may get lucky...
 

chancer

ɔ ɥ ɐ u ɔ ǝ ɹ
Messages
9,358
Reaction score
97
Location
COMFORT, TEXAS
On a small kids Kart with the 79cc Predator. I had 20mm wheel hubs and a 3/4" Axle. I made a shim out of 26g sheet metal. Works very well.
 

Fallenleopard

New member
Messages
194
Reaction score
2
Location
N.S.W Australia
Bugger, was hoping there would be a cheap way out. But I'll look into a shim or local Shop that could bore one out.
Thanks.
Have tried to attach a picture. Shaft in question is the one on the gear box. Is keyed and has a hole in the end.


Sent from my SM-G930F using Tapatalk
 

Attachments

  • 20160928_180333.jpg
    20160928_180333.jpg
    92 KB · Views: 9

mckutzy

Well-known member
Messages
8,353
Reaction score
113
Location
bc, canada
Curious... Does the input shaft of the transmission require counter rotation to the motor in order to work or go forward.......
If not.... You going to go fast in reverse...
 
Status
Not open for further replies.
Top