10Hp Tecumseh Hating me

Status
Not open for further replies.

solomon

Active member
Messages
1,648
Reaction score
8
Location
ca
well i had it running the other day, it ran okay. I went to start it today and no start, so i checked and i had no spark, wasn't grounded so i checked the points and they were shot, replaced the points, gapped at .020 and now i have a nice spark, but now it only runs on a shot of starter fluid, clean gas, clean main jet in the carb, just took it apart and it looks fine, what gives?
 

Kaptain Krunch

Pro Junk Collector
Messages
4,636
Reaction score
6
Location
vermont
Did you line the marks up on the cam and crank gear? was it running on THIS carb the other day?

Main jet means nothing, its your pilot jet that needs to be clean.
 

solomon

Active member
Messages
1,648
Reaction score
8
Location
ca
yup, running on this carb, and timing gears were aligned. Whats the pilot jet? the one that goes from the main jet into the venturi of the carb?
 

solomon

Active member
Messages
1,648
Reaction score
8
Location
ca
that is what i was referring to as the main jet, it is clean. I tried adding a different carb today (adjustable carb), but gas pours up inot the venturi. The float is set correctly and the bowl is on correctly.
 

solomon

Active member
Messages
1,648
Reaction score
8
Location
ca
yea the float was stuck, i fixed that, and now i can get it to start on choke and then remove the choke and manual rev it, but no idle. So im getting closer, what is now?
 

solomon

Active member
Messages
1,648
Reaction score
8
Location
ca
When i rev it i can feel gas spit out of the intake on me, so I was thinking rich, i tried turning in the bottom screw, assuming thats lean and it wouldn't start at all. Also i checked and i have no air leaks, motor hasn't run long enough to do a plug chop either, thanks
 

solomon

Active member
Messages
1,648
Reaction score
8
Location
ca
okay update, im getting no spark,again. Im getting oil all over my points. The seal looks good, and it never did this before. I put 1Quart of 5W-30 oil in it.
 

solomon

Active member
Messages
1,648
Reaction score
8
Location
ca
motorcraft 10W-30 synthetic-blend
 

Attachments

  • IMAG0023.JPG
    IMAG0023.JPG
    160.9 KB · Views: 7

solomon

Active member
Messages
1,648
Reaction score
8
Location
ca
what could the problem be? This seems to be a very rare and unheard of problem.
 

freakboy

the names 'mater
Messages
3,961
Reaction score
2
Location
hick town
over a long time the build up of crap with normal oil helps seal better and synthetic removes all that crud and makes it leak like a sive... it happens alot with old engines that were never ran on synthetic the gunk helps seal and that stuff cleans it away and then it will seep past.
 

freakboy

the names 'mater
Messages
3,961
Reaction score
2
Location
hick town
idk anything bout detergent and non detergent but as long as its pure dino oil it should be good enough.
 

solomon

Active member
Messages
1,648
Reaction score
8
Location
ca
I just don't know what to do. The motor is useless right now, because oil get on the points and then they stop working and i have no spark. What do i do?
 
Status
Not open for further replies.
Top