10hp briggs pull start

[trekkie28001]

I just got a go kart with 10hp briggs. The pull start does not move the flywheel. It pulls and retracts too easy but will not catch. The flywheel will move fine when I turn the shaft. It will start and run fine when the pull rope is working.

 

[Russ2251]

Repair depends on 2 possible recoil types.

 

[KieranM]

could be a case of not having the right recoil. Take a look at other 10hp recoils and check if yours looks the same.

 

[trekkie28001]

Idk what type recoil it is its a side shaft with differential and the pull start looks like the same on my push mower. It turns the shaft that supposed to catch the flywheel. If its like my mower it will be a ball bearing gear type but i havent taken it apart yet.

 

[KieranM]

got any pics?

 

[Russ2251]

If its like my mower it will be a ball bearing gear type

If this is true, simply disassemble and clean. Should be no lubricant on balls or ratchet. Oil makes them stick.

 

[motor_head]

yup the balls need to be clean and dry, you should oil the shaft while it's apart

 

[trekkie28001]

It was the balls had stuck to the outside. I took them out and cleaned them and it works now. I posted a pick of it. If this happens to you just remember to check you balls.