Search results

anderkart;145929 ok thanks for the advice i will move it , also curious why is your left front tire so wide compared to the right

i have just welded 2 out of 4 sides for the moment just because if their is any changes as i am about to make

good point i will make do that but i made a mistake as well in the post above , i made my spindle have 12 degrees camber angle not castor angle so i will be cutting it up and adding castor angle

@ toystory i have it setup atm with a one piviot on the pitman arm . (just not pictured) and same thing. so when i first built it i had a 10 degree angle , on one side of the frame and i had my spindle shaft at the same angle but fliped and it was level when the tires were flat , but when i...

like do u mean make it have a toe in ? the right side was straight as i was tessting it just in the picture i didnt ajust it yet

hi guys just starting my kart here and i have a few concerns when i go to turn it doesnt turn as snappy as i would like and it kind of slides foward a bit i thought maybe it was because of my steering setup but i have to different arms one with one pivot point and the otehr one (in pic) with...

ok thanks guys what about the rest of the frame you think it will work out good ? im not sure what kind of engine yet thinking 125 or 250cc dirt bike because it has clutch and gears

i tried this but maybe ill try a longer one

ok here it is i hope it helps

thanks for the quick response i have the angle set up so that the holes align , just n the picture the tires are turned a bit , but i have made a mock up of the steering components because im not sure what im going to do as far as it goes yet because it wasn't working , ( i do have longer...

hello i have a few problems that i need advice on wtih my go kart im building . i have my spindle arms line up with the center rear axle . however when i turn it seems the out side tire is slightly turning sharper totally reverse than ackerman. and also when i turn it turns sharp inwards but...