Search results

just googled remote kill switch several companies out there make them looks like they run 50 bucks and up try 3Build LLc.com

actually you can get the bolt on parts for a remote kill switch from radio shack or other electronic store for remote control robot or rc cars and trucks my son called and told me about it i think some of the imported quads have one on them

hey i fixed one for my grand son i put phony petals in so they thought they were making it go then just adjusted the throttle at and idle if they crashed (which they did, no damage)

suggest putting her in a booster seat safer and help her see over the wheel, i just tightened the screw on the throttle control on the motor so they can only go so fast i attached some blocks the gas petal so the kids cpuld reach them and yes youcan reduce the gear ratio so its slow (learned...

soon i hope life gets busy, got a coyote hunt today tomorrow marking jeep trails putting new winch on jeep friday sat got the great grandkids coming down (fun,fun,fun) and taking the boat out sunday. waiting on free parts anyway

well started putting it back together remounted the rear end ussing some of the old stuff till i get new shocks and chain and a few other items started moving the electrical new lites ignition transfer think i ll mount the battery in the front (a little more protected

bench the heck with a go cart i have a work bench that will do 50mph heres some pics

havent decided yet, just going to bench test every thing then go from there

right i think 50 is jsut a bit more than im looking for checking around for some other sprockets i think 3/4 9 was as small as i could find for a 520 chain. that should give me a little low end torgue. iwas wondering about the j/s input should i go smaller or bigger for more torgue (its real...

39 on axle ya i'd like to reuse it till i can fabricate a adapter for hub on axle want to get it at least get it running before i take it apart to repaint and run all the wires and cables right now the back end is sitting on bench to get the motor mounted and jackshaft stuff installed Hey just...

heres the parts i got from my friends 3/4 keyed jackshaft, 6 inch 3/4 v-belt pulley, 3inch 1 inch bore vbelt pulley. 3/4 18t sprocket (520 chain matches axle sprocket. still waiting for pillow blocks lost all the gear set up stuff think i'll need larger drive pulley (1 inch bore) gonna try this...

still waiting on pillow blocks should get them this week oh well got to go gold prospecting for a few days instead whats with this site it took 10 times to log on ??? finally made it

just a question im doing almost the same thing only with a larger chassis and 11 hp HF ibelieve the motors have the same size out put shaft (1inch 2 &/8 long ) what kind of clutch and where do i buy it

oops the one on the left is the one from yhe motor:oops::oops:

pulley heres both pulleys one on right was on engine

drive thanks for your feed back. it just seems i'm not explaining well enough and i'm not sure of some of the terminology i've enclosed a few pictures to kind of explain it just seems that if i replaced the pulley that came off the motor with one that had the right size (1 inch) i could save a...

drive here is a picture of the orginal drive setup, small part on right is mounted on engine (shaft 5/8) ( new 1 inch) left side appears to be clutch which is mounted on trans or jack shaft 9622[/ATTACH] see thumb nail

output on motor is 1 inch not tapered with 1/4 inch keyway 2 7/8 long , what size chain would you suggest im thinking 520 maybe . will a centrifical clutch hold up i live in the desert and do that type of driving a few hills and lots of sand.

thanks for the reply it took awhile to get a response i kinda blew it starting a new thread

pic here the pics