Search results

You were right that it was too small. But it was close enough to drill out pretty easily. Looks like it will work. Now to mount this thing and see if it will actually move this little cart. Thanks again for the advice.

Thanks a bunch for the offer. I just now ordered this sprocket, the 10 tooth 3/8th bore. I'm just keeping my fingers crossed that its the right thing. It looks like a 3/8th" shaft and is flat on either side. http://www.electricscooterparts.com/sprockets.html#35 The motor itself is this one...

We figured out that the sprocket on the cart is a #35 I haven't been able to figure out where to get the sprocket for the motor yet. Thanks for the follow up!

OK, I was assuming that the spacing may change depending on the radius of the sprocket and the number of teeth. Guess I was thinking of this wrong. Thanks

Thanks a bunch for the reply and the info. I had seen guides like that for determining the chain size by measuring the chain, but not exactly sure how to go about this by measuring a sprocket. Measure from low point to low point between the teeth? The motor is basically this one (copied from...

Hello, I'm just getting started on an electric cart project. We have bought an old rolling chassis that’s pretty complete. We want to run electric and keep it cheap for starters as this is as much about the build with my son as it is the cart. I figure that once its working and I see that he’s...