Search results

no

Just tested it out again, the whole engine jumps a little and it almost sounds like it is attempting to turn over so the engine is spinning.

I checked the wires on the cdi a while back and they all looked fine. I will try do some multimeter testing on it though, as well as unplugging and re plugging stuff.

But when I jump the solenoid the starter turns. By jumping I mean putting a screwdriver in between the two bolts on the solenoid. I may be wrong but I just seems like that would eliminate most problems with the starter. I response to the solenoid testing, I put a 12v tester on it and the side...

I followed the wire to the point where it connects and meets up with the battery negative on the side of the drive belt cover. I didn’t see anything that would be stopping it from grounding.

I found the connection on the drive belt cover where there is a bolt that holds down the wire green wire and battery negative wire. I cleaned Borge of them and the connection. I also cleaned the battery terminals and wires, but all to no avail. Any idea where I go from here?

Thanks, I actually offered to do it for her just for the experience.

I will be back in the garage Monday and I will attempt to follow that wire again. However, when I measured the other three wires, they were actually only getting about 11.4-11.5 volts, not a full 12v. I thought that was just normal but after reading your reply it seems like that is not enough...

Hey y’all, my name’s Parker. I’m 19 and I love teaching myself how to do stuff, so here I am in the middle of my first go kart repair. It sat for about a year and my cousin wants me to fix it for her so she can sell it. I got it running already after putting a new carb in it along with a few...

Trailmaster 150XRX Not Starting, Solenoid Clicks (Need help) I have a Trailmaster 150 XRX that sat in a garage for about a year. I put a new battery, new carburetor, and new tank of gas in it and got it to start and run/drive. However, over the next couple days it started to die. I would...