Search results

Finishing up the last few things- but she took it out and the turning is 100 times easier. Held up and didn’t have any tires fall off or collapse. Haha Got the scooter controller installed and moved the aftermarket battery to the back as well. Then put the original batter back in the front and...

Ordered an 11 inch steering wheel today along with that steering wheel hub assembly and a few shaft lock collars. I’ve got one side bolted on and it feels solid. Used 6” L- bracket to tie into- 3 5/16” bolts to hold each one in place. But a steel plate down on both sides and also has an...

Also, you think something like this would work ok to be able to attach a larger steering wheel- would let me get away with not welding anything. From bmikarts-

So things have been going slow- work/life has been hectic and never a dull moment. But finally was able to make some progress on the rack and pinion. Purchased 1/4” tie rods at first, but seemed to flimsy- went back and got the 3/8” and are much sturdier. Trick is going to be making sure I...

So I had a longer and better explanation but somehow it all got deleted. But I ordered a rack and pinion set up for the Peg Perego Gaucho Rock’in edition since the cars were the same width. Crossed my fingers it was going to be an easy job- of course it won’t be at all. Where the steering...

Here are a couple pictures of the side view and front of the Jeep. As you can tell got a little too big on the roll cage I built as well as a bit too much light for the light bar. Haha The last picture shows the 24V addition of the RZR. It’s about 2.5-3” wider but uses a rack and pinion I...

First post and new to the forum- tried to do a few searches and didn’t see anything related. I have a little girl and trying to make the steering on her Peg Perego RZR 900 12V ride on Jeep easier. Will putting a go kart steering set up make it easier or harder to steer? I replaced the plastic...