Search results

I have already come in contact with them. They have no parts in the USA yet, but they are in the process of starting their office here.

Would this kind of engine Mount be possible to mount on here. Like can the mount just clamp the piece in the middle of I were to drill holes.

I found the correct banjo bolt for it. The brakes fully work now. Thanks to everyone.

Does anyone know what bolt i need for the end of the brake cable? because when I try to bleed the brakes the fluid just comes out of this end. When I covered it with my finger the fluid came out of the bleeder screws.

SO, I came in contact with Biz, and ordered the caliper. It arrived today and it does mount on correctly! Right now the tube running from my master cylinder has a little bit left over black fluid inside of it. I was wondering If I have to get this leftover fluid out, or if I could just add...

I got the clutch and set everything up, but I just tried riding it for the first time and from either the chain, clutch, or engine, it felt like it was bumping or like a kicking feeling. I was able to feel and hear it. Could this be possible from a chain being loose? because my chain is a...

What if I were to use a torque converter? What speeds would I reach then? Would it be fine to have a 4.83 ratio when using a torque converter because I already ordered a 58t #35 sprocket and there are only 12t #35 torque converters.

The outside diameter is 11” I already ordered a 58 tooth sprocket. What speeds should I be able to reach?

Would it be better to have a split sprocket or one piece? And how many teeth should i have on the sprocket? I will be using a 12t clutch, the kart weights around 140 lbs with out me in it, and it has 11" rear tires.

Have you tried to re-bleed the brakes?

The grooves in the clutch were tiny. However I’ve been trying to get the wheel hub off all day and I just realized that there is a axle circlip keeping it from coming off. Now I just need to get the axle circlip off and I’m going to switch it to chain drive. ---------- Post added at 08:23 PM...

Well I got the belt clutch and it is not going to work out(Way to small). Does anyone have any other suggestions?

There USA location is about 15 minutes from my house. I’m probably going to go by there sometime next week. But it is a office building and not a store.

When I bought the frame it seemed like a great deal for 200$ Bc of how much their new ones sell for. Now it doesn’t seem that way anymore.

The master cylinder does work, but none of mcps brakes fit a .3125 wide rotor. Biz hasent responded yet.

The shipping price from the United Kingdom is about 70$ plus the cost of a new brake pad and piston is it just worth it to buy new brakes, Can you suggest some that would mount correctly to my kart? The rotor width is .3125 in

Does it look like the piston is missing on the side that the brake cable goes into though?

I just checked their site and the only brake pads they sell look as if they would fit right on. However, I don't know how these brakes work. What in the brake will be pushing the pads to clamp the disc? One side is hollow while the other is filled on these brakes.

I'm not sure its a Biz part though because most of the parts on it are not BIZ. The inside of the brakes look like they have a certain bolt pattern that will fit brake pads. Are there some cheap brakes i could replace this caliper with and still use the master cylinder.

It is a BIZ go kart frame. I took apart the caliper, heres what the inside looks like.