Search results

My other question is is junction 2 need to be connected to try this out. If so how do I connect the diodes? since my reverse controller is so different?

so I presume that there is a newer style reverse switch then, I was guessing there was. I will use this one to make sure my design worked=s then replace components as I can. thanks

[/ATTACH] front and back of the reverse switch. the open post went to the positive battery. (Correction, it came off the old controller...)

Not great pictures but will get more tomorrow. thanks

Got that controller, but I am a little confused with the install. I have a mechanical reverse switch, I think the one in the wiring diagram is electric reverse. http://kellycontroller.com/mot/downloads/KellyKDSUserManual.pdf what can u tall me about the difference between the install on these...

One last question, can I use a 48 volt controllers with 36 volt motor, that way if the motor goes out I can buy a 48 to replace it. Thanks

Will there be a wiring diagram with controller? I plan on calling them today and ordering both. thanks again

Hope this is clear enough. Thanks.

OK, I had read on cushaman the first two numbers were, but that really does not matter, as I will not be ordering parts... ;) I am just thankful for all the help.

I have figured on that, I did not know that it pull full at idle. I have heard the motor will handle 48 volts, but need a new controller, is that true and do you have a recommendation on a controller? The model says 1970, but it might have been old tech then. thanks for your help.

here are the pictures, I put an insulator under the controller contacts and it still moves. I am guessing I might have to replace the controller.

I cant see the attachment button, must be blind. :)

I cant get pictures to load from my phone, will keep on that. I agree it might have been rewired, but the controller, a bowl shaped item with 5 contacts in it, the mechanical part works fine. I assumed that the rest position would disconnect from the moter, but even if i isolate the contact, so...

Sorry did not say it's electric. 36 volt.

I have an cushman golf cart model 7010. My problen is as I am testing it, it starts to move as soon as I shift it into forward or revere. After that it work normally. any ideas on what would cause this? I plan on moving all components to a cart I am making. But need to solve this problem.