Search results

'sid, I understand your concerns with not re-drilling correctly however, I was thinking about machining a fixture, with the correct pattern, that will fit in the center of the wheel (thus centering the fixture) and then drilling the new holes. Here's a quick sketch of what I'm thinking about...

Thanks Poboy... As far as drilling the wheels, I figured I would just make a drilling fixture with the new bolt pattern... accuracy should be no problem.

Thanks again for the response... After a more accurate measurement, it would appear that the bolt pattern of these hubs / wheels are 4 on 90mm. I'm not sure that I will be able to find hubs with a 1" id and that bolt pattern. What I might do for the time being is purchase the 4 on 4 hubs and...

Thanks for the responses... The hub and wheels are from what I believe to be a Path Winder. When I get to the shop tomorrow I'll check the size of the wheel studs and the nuts. Also, I'll check the measurement with a metric rule. All I have at the house is a tape measure. The original...

Thank You itsid, we'll do.

That's about the worst response to a request for assistance that I've ever seen... actually not really, it is pretty typical of the elitist attitude often encountered by newbies when looking for advice on “specialty” forums. I have seen it over and over in forums on which I am and used to be...

Do you figure this hub is a 4 on 4 or a metric hub. I need to find new hubs to match my wheels but I'm not sure what the size is. Any help would be appreciated.

You're right, looks like the fan cover was replaced... regardless, it does run well. Any advice on the axle parts?

I've been lurking here for a while trying to glean as much information as I can before asking any questions. …and have found some great info, not to mention inspiration for a future build. What a great group. I recently purchased an old Path Winder cart as a father and sons project. It has a...