Search results

Awesome diagram.

Looking good. Quick question though, if you were going to hook a kill switch up which wire would you tap into

I got it, been busy with my kt100, but finally found time to rewire it, and got it all set up. Thanks for the concern though.

Once I disconnect it there is two yellow wires, I was curious as to which one I needed to hook it up to. Thanks though

There is two parts to the wire when I disconnect it, I am not reconnection it. So do I splice this into the "top" wire/

Sure did, and did not see what I'm looking for. I was just curious if anyone who has a predator and has linked up the kill switch could show a picture of exactly what wire they tapped into.

Anyone have an actual pic of it set up?

Thanks, which side do I wire it to? I am keeping it disconnected since I have read it causes issues around turns.

Thanks for the help guys, ripped the motor out and picked up a predator 212 to put in it. Now if someone could just post a pic of what wire they tapped the kill switch into I would be set to swap it. And yes, I searched, but could not find a pic.

Ok, so I should take off the plate by H, where should the fuel line go that they had hooked to the carb.

Good point in ordering the parts, I'm just Thu king drop $20-30 on stuff that may fix it, and it still not work,or $80 on a brand new one.

Irs some kind of epoxy on the plate, I'm guessing they tried to seal a gasket instead of replacing it.

So just take it off, and put a fresh one on?

Ok, here are some pics, please help. As you can tell from the pics, it looks pretty messed up. First off I have my doubts the fuel line goes to the carb, I hooked up the spring to A, then the arm, but not sure its correct. No idea where to start or how to get it to turn on. Is this fixable, or...

Haha, understandable man. As far as the gas, I already soaked it when I went to fuel it up and didn't realize the fuel line was not connected to anything. I will try and post some pics tomorrow so you all can help me a bit. I will work on that profile as well. :useless:

Butterfly valve? Sorry, thought I knew small engines, I was wrong.

No pics yet, hopefully will get some posted tomorrow but hopefully someone can help without. Long story short picked up kart that was "throttle stuck wide open" trying to fix it. Not sure what to hook to what, there is not air filter on top of the card, nor the "tabs" for what I am assuming the...