Search results

Gaver?

1" solid steel axle, no pics but its an over all bend, wondering if I need a third bearing in the middle of the axle to relieve the strain, or shorten the length of the axle so the wheels are closer to the frame.

Need axle help We found an awesome trail the other day, but unfortunately the bumps were a bit too much for the axle. It bent and I don’t know why, before I go and buy a new one, can someone help me understand why it bent and maybe how I can prevent it from happening again?

I don’t completely agree with that, if I hit a big bump, or a sharp turn I don’t want to be thrown, the wide nerf bars, the tall front, and the high piece above the seat should be enough if you roll.

Progress...She's ALIVE We took it out for its maiden voyage, OMG that was so much fun, that 420cc Predator engine is awesome, very quick and lots of speed. Everything went well, and nothing broke…yet Here are some more pics….if all goes well after beating it up for a bit, we are going to tear...

Here are some pics of how I compressed the Driven, and some of the Driven installed….let me know what you think.

Still couldn't find anything, so I just went ahead and did it, don't know what I was afraid of it was easy.... But I have one question...when rear wheels up off the ground...should they gently spin at idle with some resistance to stop if I try to hold them?

OMG can someone find me step by step instructions for removing the red spring and installing the yellow spring.....been searching all day but can't find anything......HELP....PLEASE!!!!:mad2:

I knew it was on backwards but…I keep looking at the red spring and it looks like it is supposed to work that way. The coil looks as if when spun it wants to contract (good) like it should, I have the yellow spring and it looks like if I install that one it will want to expand (bad) am I not...

PROBLEM with Torque Converter Driver is engaging at idle: Recap of parts and pieces: 420cc Predator engine 40 Series Torque Converter Center to center (shaft to jackshaft) 9.75” Belt is 203788 The driver expands out and grabs the belt at idle, I don’t know if the idle is too high or if I...

I need one for a 40 series 1" driver.

The brakes are already on the other side, as seen in this older photo.

Jack Shaft Help Can I get some feedback on this design?

Looks Awesome.....how fast do you think your going? What is your ratio? Please keep in touch. :wai:

Can't find the spring to do this, any Ideas?

Well that was easy!

Great idea! what type of connection could I use on the choke handle to connect the solid wire?

:lolgoku:

Extended Wire Harness: Ok, our 420cc 13 HP Predator motor has an electric start, which is good, but not if you want to start it while sitting in the kart, I extended the harness about 6’ so that we could mount the key switch somewhere near the seat. You will need 18ga wire, different colors...

I am wait for this model to come out of production. It's new to the market, and have never seen anything like it on ebay.