Search results

Sid, give me a couple days to get pics posted. Rocketkart, I am in North Port which is just south of Sarasota. Are you nearby?

It is a 3/8" nut (being used as a spacer) because the bolt is too long...but that doesn't make the motor shaft any longer. if I come out 3/16" I will only have one 1/16th of an inch on the motor shaft and I would need a longer spacer behind the driver. I doubt that one 16th of an inch is enough...

Could somebody post a pic of new driver weights so I could see what is worn off of mine?

So I have bought this used Yerfdog 30034 and am trying to determine a few things in order to get it back working well. The belt on it was used and so I am not sure if we wore it down or if it was already this bad. See the pic below. When these are new are they exactly 3/4" wide? If so, this...

Finally got time to get the idle jet out. Sprayed some carb cleaner in the side of the jet, but none came out through the jet. Took a small piece of stranded wire and ran through the hole and then carb cleaner would spray through it. Put it back in and it now idles perfectly. Thanks for the...

Awesome diagram. Thank you.

10-4. I'll take it out. I let you know how it goes.

No I didn't try the wire yet. I'll do that when I tear into again.

I've been thumbing through the threads on this site and have learned a bunch. Lots of knowledge to be had here. I have purchased a used Yerfdog 3003 with, what the seller claimed, was a new engine. It looks like it has had very little use (like maybe 2 to 3 hours). The seller drove it for me...