Search results

So take the chain off and spin the whole rear axle setup? And we want it tokeep spinning until it come to a nice gradual stop. I'll give it a try tomorrow and see how it goes. Thanks

She's a brand new clutch guys, brand new 60t on my axle and 10t on the clutch. When I saw the smoke I shut it down and the clutch was red hot. I Wonder if I've got some unnecessary load somewhere along the axle maybe. Or perhaps these clutches are garbage.... I'll get a weight on it tomorrow...

Hey guys, (shout out to hellion for the sick post!) So I slapped the 60t on with the new clutch and she started smoking again.... The brake is not on and I'm not pressing it while driving. Could this just be factory grease burning off? I was flooring it too, to avoid the clutch from slipping...

Oh right, my bad. Well I really appreciate you helping me out! Thanks again guys!

I didn't smoke it on purpose, haha. Didn't really want to buy a second clutch! Is there anything I should do to a new clutch? Oil, or grease or anything? I'll purchase a new gear tomorrow, so I should grab a 60 tooth right? Thanks!

Thanks for the super quick reply guys! 208cc clone, so I assume 6.5 ish hp. So I should grab a 60 tooth and a new clutch? Does this decrease acceleration and increase speed? I suppose I don't really know how fast it is since the clutch wasn't functioning properly. Thanks again!

Hello everyone, Just finish building my kart and the clutch was pouring smoke. I tried it a couple times and still the same smoke. I've got 10 inch tires, 4 inches wide. 10 tooth cent clutch, 48 tooth gear. I'm about 240 lbs. I have a feeling my ratio is to small. Thanks for any help you...

thanks for all of the help guys! i live just south of calgary near okotoks, not to worried about cops since i live in the country with 2 newish communities with tones of quite roads to rip on. ive seen a site online that says you can build a clone engine up to 26hp? that cant be right can it...

hey guys, ive been wanting to build a go kart for a while now and i think now is the time. would it be ok to use 1/8 of an inch 1x1 square tube to take care of all of the frame work? i want to make it on road only so what kind of tires would i use? 6 inch? also ive been doing some research on...