Search results

Hello everyone, this is the rear end of my yerf dog to which i have just welded bearing mounts for my jackshaft. My friend just bent the shaft while pulling out of the steep driveway, between the right pillow block and the small sprocket. He was trying to stop at the top of the driveway, but the...

Hi guys. I need help determining whether it's OK to cut off this bar or not. As shown in the picture, it wastes alot of the precious legroom for the passenger (which is quite scarce to begin with :lolgoku:) I have no idea if this will ruin the structural integrity but seeing as there is not one...

Hey everyone. My buddy and i just took my restored Yerf dog on its maiden voyage down the street. We probably drove it for a mile. Anyways, as we drove it a few times we noticed this black rubbery powder accumulating on the engine. We then drove up a small hill, which it handled fine. Then...

Hey everyone I'm installing a jack shaft in my Yerf-Dog so I can run larger rear tires, but I don't know what diameter to use. I'm either going to use 5/8" or 3/4". Is 3/4" considerably more durable? However 5/8" seems to be the standard, and 30 series TAV2 drivens have a 5/8" ID. Is the 3/4...

I just bought an old Yerf Dog frame off craigslist for $150. I think it's model 3002 but not sure. It was in pretty bad condition, missing the engine, rear wheels, hubs, and almost every bolt had rusted and seized. The front wheels were trashed. It even had two mismatching shocks on it XD It...