Search results

I actually have a little extra cable here. I'll tinker with it later. Got dad duty to run the kiddos around for a little bit.

That makes sense. The throttle cable had a little ball at the end of it that I had to cut off. I didn't trim any sleeving off. I'll check that.

I'll check it out, thanks. I think something's not right with my throttle setup. If I give the wire a little slack it won't pull 100%. Maybe 60%. If I set it tight enough that I can give it 100% throttle, it's idling high from the cable being tight. I think I can add a spring to pull it back...

This was my 2nd attempt at a launch. The first time I didn't have the throttle cable tight enough so it wasn't getting enough go juice. I did loosen the chain slightly but it still feels a little snug and likes to creep at idle. It wasn't at initial install but it got tighter. I'll continue to...

The calm before the storm. https://photos.app.goo.gl/h4GZUjqXwP18SgjP8

Well, you saw...it was loose. So loose, I could slip it off. Now I can't. And these 🍻 aren't helping me explain. But...what I'm trying to say is the full send video will be tonight. Stay tuned.

So, I've got a couple bolts in the bracket. The motor isn't secured yet but isn't moving. The chain isn't tight but isn't lose. The belt is so loose I can slip it off without removing anything....but it wants to pull. Even at idle. Now, the cart is still up with no wheels, but the axle is...

I've been watching some videos and I probably will replace it at some point. It doesn't look as hard to as I originally thought. Right now I need to get 2 carts running dependably.

As much as I want to see this thing running, I'm going to take a night off. Long day at work and I'm tired. I'll get her going tomorrow night when I can take my time and enjoy it.

I heard that was better than the stuff that's now legal in some states. Funny though, no one that says it has first hand experience.

It was just for test alignment. It was late and I was tired last night. I overslept this morning, lol. If I end up using anything like this the washer would be placed between the tubes and the steel mounting plate so the motor will sit flush with the tubes. It was just easier last night since I...

Why did you mark the drive and driven bolts? Is that so you can check to see if they're moving after a ride?

Sounds good, thanks. It does look pretty loose, both in the pics and in person. Worst case, I can try the smaller belt if it slips. I'm hopeful that I get it mounted tonight and take her for a test spin. As much as I want to floor it and measure the marks, I'll have to take it slow for a little...

I did. It's seated snug. It's 203591. I thought it looked a little loose. Center to center is about 6-5/8". I can take the belt off tomorrow and measure better. I'm calling it a night. Gotta work in the morning. At this point, the chain is turning freely but I'll adjust some more before I...

The 2nd time is a little easier.

That sucks. I was matching the picture and completely overlooked where you said that. I'm lining up the motor now. I had shaved the fins and I'm going to have to shave some more. The corner is catching.

That's the same hole?

Got it!

I'm going to try the red one before I upgrade.

I vaguely remember that. 🤣😂 It stays in the cam. My problem is I have a full half turn to make and when I lift it to get over the last hump it pops out of the other piece. I'll get it eventually.