Search results

Also made a tab to attach the ignition switch on.

Bolted the front end together for good. Only thing left up front is a tab on the passenger side spindle, Reinforcing both spindles, packing the bearings and tie rod ends. Built a battery tray. Just need to finish building the hold down clamp.

1" jackshaft I ordered has been sitting at a FedEx terminal for the last 8 days. I ordered another one, this on from BMI karts with expedited shipping.....

Received the steering joint that goes with the rack and pinion. I had to shorten the original steering shaft. Installed a heim joint to support the steering shaft. Also installed an extra small led light. It won't do a whole lot. It's just in case we get caught out after dark. Pulls 1.5...

Motor bolted down today

Lol

Got the rear sitting on the wheels now. I had a feeling these chinese shocks were going to be too stiff and they are. While bouncing on the rear rack I get about an inch of travel. So, I ordered another pair of shocks to match the front. Should be here this week.

So the front end is together. Like how the shocks feel. Started mounting the steering rack.

The tube will need some support in the middle. The hubs are trailer spindles and hubs, 4 on 4 bolt pattern. Most all golf cart rims are 4 on 4 so there's plenty of options.

3/4" heims, couple weld in bungs arrived today. Also picked up 3/8" & 1/2" fine thread bolts for the spindles.

Main tube is 1-1/2" x 1/8" wall dom. Bungs in each end. Well see how it holds up

Looks like the Driver is on backwards and the cup on the driven is on the wrong side of the slider button.

Here is the new steering knuckle in progress. The old design did not give enough steering angle. So I scrapped them and will be laying the heim horizontal. Bolting the heim joints down into the spindle. Using a 1/2" heim on top and 3/4" on bottom. Lots has happened since the site had been down.

Also playing around with engine, jackshaft placement,

Seat covers from summit arrived today. Got them installed and bolted the harnesses in

Wow was able to load the page today!

.

I've tried to go back to this thread several times and got the same error untill now.

The site is back up and running. Started front A arms. Started welding up rear bearing support boxes.

.