Search results

My stock #30 torque converter has a stock red spring in the driven....help me understand....what is the result if I replace it with a yellow spring...a green spring ? does that change the rpm at which the converter engages, or just the torque ( or bang) when it engages. ? What I would like to...

pedal pump bleeding doesn't work, there's just not enough "throw" in the pedal to push much. Bought and tried a vacuum system for bleeding, that didn't get much. now going to diy a pressure system out of a garden sprayer....any brilliance out there......It a new system.. new master, and new...

Looking for an 1"steel solid axle not bent or tweeked, length doesn't matter. hopingfor a hot deal !...Thanks California gary_clarke@att.net

Bldc 48 volt motor and matching controler ...6-1 sprockets...everything has worked well for 10-12 rides.....when rear wheels are off the ground everything spins nicely. when a rider sits on it and attempts to drive.... you hear a sound which sound like the chain skipping over the...

I know this has probably been covered....but I can't find it. As an adult I can wrestle the steering to keep steering smooth, but I'm sure the grand kid can't. How can I smooth out the Kart twitchyness in the steering. Lengthen the pitman arm ? shorten the pitman arm ? lengthen the tie rod...

I've seen the recommended ratio of 6 :1 seems for gas karts. i've built a 48volt/1800 watt...cart weighs about 150...rider weighs 200 currently 12 tooth drive gear and 54 tooth on axle..is this within recommended ratio for electric ??? Tanks Redflash

just picked a 1968 Rupp frame....here's what I've done so far ( pictures to follow ) extended frame 9 inches straightened bent front axles powered by 48 volt electric motor 1800 amp 48 volt controller and throttle pedal 18 inch rear lawn tires on 6 " rims 13 inch front tires on 6 inch rims...