Recent content by ZR2Chevy22

  1. Z

    what is the safest brand engine to buy.

    I didn't say anything about selling it. might just transplant it to a my Baja mini bike :-)
  2. Z

    what is the safest brand engine to buy.

    If I were to replace my 5hp flathead with a predator what would I need to do to my predator in-order to run my current comet 30 torque converter? It looks like there's a plate mounted under my motor that the jackshaft and driven unit is mounted to and the drive unit is bolted directly to the...
  3. Z

    Dies when no choke

    I screwed it out 1.5 turns when I rebuilt the carb like I read in a writeup on the pulsejet carb rebuild. I screwed it out to 2 turns today and it will now idle with the choke off. The slowly started closing it until it sputtered from to little fuel then went up about an 1/8th of a turn so...
  4. Z

    Dies when no choke

    Solomon, I cleaned the entire tank and all mating surfaces I used new gaskets all around. 88, I know not to bottom them out to hard. I screwed it down just till it touched then backed it out the 1.5 turns. I will go another half and see if that lets it idle with the choke off. If not I'll go...
  5. Z

    Dies when no choke

    Well I have a Briggs and Stratton 5hp Fun power engine and I have the same issue. I recently cleaned the carb and used a carb rebuild kit for a fixed jet pulsejet carb. Made sure everything was clean and clear, put new gaskets, pump blader and all. mine will idle fine with the choke about 1/4...
  6. Z

    Looking for Help Identifying this go kart

    Well then we have something in common. LOL
  7. Z

    Looking for Help Identifying this go kart

    Well I work this weekend so that would be out. 6pm-6am Fri-Sun. Get every other weekend off. I also don't accept free stuff. I worked IA in the past and did new hire orientation and preached about not being above anyone else and why should you get something the old guy in the corner who...
  8. Z

    Looking for Help Identifying this go kart

    Hey Jim you know anyone who does wire welding? It's looking more and more like the buddy that was gonna do it for me is going to flake out on me. What I'm needing is to have the floor board retacked into place. It's lose up near the pedals and needs to be retacked in a few places. I also...
  9. Z

    Looking for Help Identifying this go kart

    In all honesty if your wanting to put a remote kill on something go with the kit that's out there. Even having the transmitter and receiver it would still be between 60-70 bucks. I just had all the stuff off an old car. Andrew
  10. Z

    Looking for Help Identifying this go kart

    Nope.. in theory it's just a little electronic relay of sorts. When open allows the motor to operate as normal. When you send a signal to it using the RC controller through the receiver, it "switches" closed grounding out the ignition killing the spark. Simple as that. I use one on my 1/5th...
  11. Z

    Looking for Help Identifying this go kart

    I got all the stuff I need in my RC bin.. Mine is good for line of sight. No need in buying it when I have all the stuff to make it.
  12. Z

    Looking for Help Identifying this go kart

    The Predator 212 is what I put on my Baja mini bike. Talking about holding on for dear life. Even with the gov still active on it it's a white knuckle ride for most people. You're right you can't beat them for 100 bucks. But if you do remove the gov it's recommended to upgrade the...
  13. Z

    Looking for Help Identifying this go kart

    Sounds good. Since the main use of this Kart will be for my nieces and nephew that would be good. I'm installing a gas pedal limiter as well as a remote kill switch where the motor can be killed from my RC transmitter. I have gas a 1/5th scale gas powered RC car I put a kill switch on so it...
  14. Z

    Looking for Help Identifying this go kart

    There better? I made the account last night at work :rolleyes: so I didn't have the time to fill out all the details but they are done now. I am off Wednesday and Thursday so I'm hoping to tear into the go kart. Engine will be first then once I either fix it or get pissed and decide to...
  15. Z

    Looking for Help Identifying this go kart

    I know the feeling.. I've been in law enforcement for 11 years now. It's a job you do because you love not because you'll get rich doing it. It's countless hours of helping people sometimes without even so much an acknowledgement or anything. Andrew
Top