Recent content by zoombyu

Hi guys, I have a pull start Predator 346cc engine on my kart. It has the low oil sensor and a kill switch. I see there is a electric start and a pull start version of this engine. I am assuming the electric start version can charge a battery. So can the pull start version charge a battery...

Well started bleeding and broke a front caliper. The caliper casting busted and the "finger" fell off :( Dual piston M/C, apparently I should have been bleeding each piston separately. Live and learn. Got a replacement, took the M/C apart and cleaned it up, drained all the lines, put everything...

Thanks. The tires are AT22 x 11-10 and with current inflation stand 21" tall. I counted the teeth on the sprockets and got the following (providing I counted right). The sprocket on the centrifugal clutch is 13 teeth. It is connected to the jack chain axle sprocket with 47 teeth. The other jack...

Got it. Will go bleed them some more. Thanks!

With the system sealed there is no change in fluid level. M/C and caliper are clean and dry so I didn't suspect a leak. There are 3 lines leaving the M/C, two for the front brakes, which work very well, and one line for the rear which is not. How much fluid would I expect to bleed threw the...

I picked up a dirt buggy go kart and the rear brake didn't seem to do anything, front two were fine. Noticed the brake pad was half on the disc and half (top area) off. In my mind it made sense it didn't work because pressure against the pad was angled so the piston probably got bound up. Took...

Hi there from Vernon, BC. Picked up a dirt buggy go kart similar to stangfuri's (don't have a picture handy) and took it for its first spin today with my son. We had such a hoot that he wants to go again tomorrow. I am not sure who's more excited, him or me :) It is a 150cc model but the...