Recent content by zims23

Here is a pic

Not sure of the model of the clutch. The clutch sprocket is 10 and the axle is 48. Didn't adjust throttle stop. The chain does have a lot of play. The chain cannot be shortened any further. Won't fit with another link out. I did raise the motor up to take out some play. I could raise it further.

Hello, I got everything hooked up with my Predator 6.5hp engine and a hilliard clutch. the kid took the cart on the road for a couple minutes. It started to smoke a lot. I went up and looked and it looked like the clutch was spraying some grease. Is this normal? I did not grease anything. Any...

zims23 I am struggling to get the throttle hooked up. the carb throttle is a push system and I need to pull. Any and all ideas are greatly appreciated. see pic. green arrows show the black throttle on the barb and the rod that pushes it. There was another throttle rod that I removed.[

I am struggling to get the throttle hooked up. the carb throttle is a push system and I need to pull. Any and all ideas are greatly appreciated. see pic. green arrows show the black throttle on the barb and the rod that pushes it. There was another throttle rod that I removed.

i now have my sprocket and engine. the motor runs and everything looks complete except hooking the gas pedal to the throttle. the gas pedal in there pulls a cable. the throttle on the new engine is a push. Can someone please offer some advice? An easy solution is preferred. thanks

I will be using set screws. The hub has 2 of them. The hub will have a weld on sprocket. Machining the axle will allow me to change the sprocket later without having to get another hub machined.

I pulled the axle with the plan of installing a new sprocket. I went to purchase a new hub and sprocket. The axle was an odd diameter. I had to go and get the axle turned. I had a machine shop take it down to the 1" diameter on a lathe.

I just took out the rear axle. The sprocket and brake disk are connected to the same hub. I would rather not flip the axle because I would have to remount the break calliper. Is there a way to mount another sprocket on the axle? Thanks for all the help.

I went and picked up one of these engines: http://www.princessauto.com/pal/en/Engines/65-HP-196cc-OHV-Gas-Engine/8088379.p I pulled the old engine out. I now have to figure out how I am going to mount. I am planning on welding a new mounting plate. I will have to move the sprocket on the axle...

It looks like it might be a Huasheng 142F http://blowbyu.ca/220601.html Anyone have one of these engines or have experience with them? I am open to putting in something different. Maybe something a bit bigger.

I don't think it has reverse. It does have electric start though.

Thanks for the welcome. I am attaching a couple pics of the engine. I have tried searching the internet and cannot find a source for the same engine. I see some similar on eBay for over $300. I am open to the idea of putting something completely different in. I wonder how hard it would be fit...

Hello, I just bought a used go kart. It is exactly like this: http://www.alibaba.com/product-detail/GO-KART-50CC_294896535.html the only problem is the motor is toast. the guy before took it apart and lost some parts. i got the unit for cheap. I would like to but another complete engine or...