Recent content by xab6980

I was putting a new belt on and took apart the driver to clean and lube, It was really dirty with caked on graphite like power on the outside drum for the driver and the flyweight's zink weight was alittle mangled with a chip sitting in the drum. Could I get away with just a good cleaning or do...

i guess there isnt one. What are some of the most likely cause of the engine running so hard? Also why are the tires spinning when the engine runs?

thats not what my carb looks like,did that pic come off a ohh-65?

The engine is running to fast at idle, I was wanting to check the idle screw to see if that would help. I got the linkage worked out(that helped alittle) But the tires are still spinning when you start it. Anybody have any ideas? Thanks guys

i dont really know where the wire coming off the gov. is really to be placed correctly(there are two wires) I placed one one the throdle cable just so you could see it in the pic. Anybody have any ideas? Thanks

Hey guys do any of you know where the wire thats proped up on the throdle cable goes? I just put it there so you could see it in the pic. Im not even sure the one that is coming off the gov. is in the right place. they were both just hooked on the same post. Any ides??? Thanks

no its running the same as before the carb was cleaned. It just wouldnt stay running before. Now it will stay running but sounds like its at full throdle, its running so hard the frame shakes. There is no black smoke. could the srew with the spring (Idle screw maybe) be to tight? or could the...

I just had the carb ungumed(Cleaned) and now the tecumseh is running really hard on this dingo. Any body know whats going on with it? Thanks

HI,the 6HP Tecumseh on a manco dingo will start if i push the primer button then run for 1-2 seconds then die if i dont push the primer. The TC belt is not the right one and is loose...Would this cause it to not run or is it a Carb problem??? Any help...Thanks