Recent content by whaleit

>>>>>P.S. just a side note, be patient...whatever is wrong is probably very simple and you just have to pin point it. The guys on this site are incredibly sharp and will help you find the issue, as they did me.

also...I have never removed oil sensor or messed with the governor and no problems to date.

you have to take the stock link arm off and put their little one on (it loaks like a coat hanger that was cut and shaped for this application)...the "throttle lever arm"...it is a real pain to get into place but with ALOT of patience you will get it. I placed the pics you requested in the...

Shown on Harbor Freight Engine. The KIT purchased from AGK worked...but as posted in Dec 2009...."The kit "throttle lever arm" was about 3/16" too long...I had to shorten it and now the "butterfly" closes as should and actually allows the idle screw to do its job." It came too long and by not...

Got It...FINALLY!!! Thanks all for your help...bknights you were exactly right and it is also exactly what 1992subburban refered to early on but I could not figure out at the time. The kit "throttle lever arm" was about 3/16" too long...I had to shorten it and now the "butterfly" closes as...

lost Keep getting..."daddy, daddy is it fixed yet"....This christmas gift is really getting stale!:rolleyes3: I ran it this weekend several times...the throttle assembly is closed...the throttle "lever" is to the "right" when throttle is closed. It seems to have nothing to do with throttle/AGK...

Thanks for the thoughts guys...yes the 10mm nut is loose and it moves easily...the cable attachment is also working fine, the "hand lever" is as far to the left as can go.. I am stumped...this new engine is acting exactly like the last...turning the idle screw CCW does not change anything...

DUH!!!! just figured out what CCW meant (thought it was the name of "adjustment screw #2)...disregard stupid previous question!

the throttle lever arm is functioning fine...working as described in last three pictures in link you sent... I have yet to touch the screws...they are both in factory positions...will try adjusting idle screw first (as I mentioned previously it did nothing on last engine and just wanted to make...

Throttle lever is closing fine.

OK...yes...that one was tricky...but just saw next to last pic and need to check that...will do so now....

oh, oh...not sure what that is...looking at instructions that came with kit and don't wee mention of it...

OK...any links to pics or a video of what I need to open up to see the "butterfly" just a real novice at this engine working stuff.

thanks anderkart...yes it does have two wire connection terminals!!

OK...I had read somewher about removing the oil sensor...will find that post again... Thanks! Getting pretty close to having this ready for my boys to try out!!