Recent content by wall

  1. W

    Gx140

    I have one brand new and two used. Yes, I am aware.
  2. W

    Gx140

    Hi, I'm looking for a simple list of mods for a GX140, jets, heads, valve, springs, crack/cam shafts and all. What should I start looking for to squeeze every hp out of these engines?
  3. W

    Comer K-80

    Now I adjusted according to the Tillotson manual and it idles fine but dies when I release the throttle after driving it fast. Is it too lean now? It is also smoking a lot less.
  4. W

    Comer K-80

    I adjusted the jets according to mcrengines and it is still dying when idling. This time I know it isn't too much oil because I measured exactly 5%. I tried messing with the low jet but that didn't seem to make a difference. Where should I be looking for problems?
  5. W

    Comer K-80

    And I still have no idea what is the correct number of turns for the high and low speed jet screws.
  6. W

    Comer K-80

    The engine was brand new, my initial problem was a too much oil in the mix. The carb is a Tillotson HL-166C and is still leaking into the lower part of the air filter mesh. Any tips on engine break-in? I've only ran it moderately for aprox. 20-30min, that thing is a beast.
  7. W

    Comer K-80

    I adjusted the idling screw until the clutch starts engaging (with the rear axle in the air) and it "almost doesn't die". I guess the mix had too much oil, I'll keep this thread updated next time I refill the tank.
  8. W

    Comer K-80

    I have a brand new kart with a Comer K-80, never used and a few years old. The thing started after many attempts and runs perfectly but dies as soon as I release the throttle and I noticed the carb was leaking gas when pulling the starter. Maybe I just put too much oil in the mix, or should I...
  9. W

    GX140 modding

    And what is the maximum rpm I can safely get out of this stock engine? Should I really remove the governor or adjust it higher until I mod it further?
  10. W

    GX140 modding

    So without buying new parts for now, should I just bore my carb, replace the air filter and try to find a cheap exhaust?
  11. W

    GX140 modding

    I was asking because if they did have the same volume and the GX160 already has bigger ports and valves I would just use a 160 head without porting mine.
  12. W

    GX140 modding

    And how many cubic centimeters does the GX140's head have? Is it interchangeable with GX160?
  13. W

    GX140 modding

    But does it reduce the engine's displacement?
  14. W

    GX140 modding

    OT: Why do some people use 160's head on GX200's?
  15. W

    GX140 modding

    Will it affect the low-end? Can I remove the whole exhaust?
Top