Recent content by ulrikwilmann

  1. U

    Need help, don't know how to remove a belt/strap sprocket

    It's filled up, and thanks for help! I'll probably figure out some way to get a clutch.
  2. U

    Need help, don't know how to remove a belt/strap sprocket

    http://m.ebay.com/itm/281876916308 is this one OK? Centrifugal clutch? Is it a clutch that goes off when you throttle/accelerate? ---------- Post added at 06:50 AM ---------- Previous post was at 06:47 AM ---------- Yeah sure man, i'll go out and check! I can upload a picture of the chassis...
  3. U

    Need help, don't know how to remove a belt/strap sprocket

    Last one; Any website where i can buy cheap clutches and sprockets that fit this type of engine? I'd be glad to know!
  4. U

    Need help, don't know how to remove a belt/strap sprocket

    I got it off! Oil n Rubberhammer! Thanks again, i know where to ask for help from now on! :wai:
  5. U

    Need help, don't know how to remove a belt/strap sprocket

    So heat and puller? I don't have any gas left for my blowtorch but is a trimmed lighter enough? (Sounds stupid) ---------- Post added at 01:05 PM ---------- Previous post was at 01:03 PM ---------- Yes! I can do that. Thank you guys so much!!
  6. U

    Need help, don't know how to remove a belt/strap sprocket

    Yep, both two of them! I don't know if it's a pulley, it's supposed to be a strap or belt on there. It's a tecumseh hm80 1985 model. 8 hp Hahah i can imagine, this is a oldschool forum but i figured out how to smack a photo in here :wai:
  7. U

    Need help, don't know how to remove a belt/strap sprocket

    Hey, i'm new to these type of engines and i'm going to build a gokart soon, but i don't know how to remove this crankshaft. Last owner broke it up so i have to remove it. Heres a picture I'm struggling to build a gokart, i do know how to weld but engines is hard for me Appreciate help :wai:
Top