Recent content by UDFxRookie

Looking for a racing clutch to handle 18+hp with 3/4" bore.

No issues getting the new cam in, put in 22lb springs and while adjusting the valve guides, turning the engine to TDC was beastly!!! Is this thing supposed to be insanely hard to turn. I have a pair of vise grips on the shaft and it took a ton of elbow grease to crank it around... ideas?

Here's more engine part pics

I just got a steel cam from DynoCams from a return Tecumseh, the plastic one has teeth just past the last cam and next to the main sprocket..... Does it matter? Can I use the steel one with no teeth without an issue? PS this is going in an OHH60

So I tried two things with one working. 1) I taped off half to 2/3 of the air filter Results: didn't seem to have any affect 2) I pressed the primmer bulb when the engine was about to stall out Results: so long as I kept primming the engine kept going... what in the world is up with...

I got a go kart that had been sitting outside by a guys trailer forever. I bought a new carb ($11) vs cleaning the old one. The previous carb setup also had no air filter box, etc so I purchased an adapter for the after market cone filter. I also replaced the ignition coil and spark plug as the...