Thanks for your replies!
I think taking the wider section down to 1" in order to get 2"s of useable shaft sounds like the best idea. Hopefully I'll be able to do it at Uni but if not I spoke to a local engineering firm who said they would be able to do it for £65 to £100. So fingers crossed for...
And I don't have easy access to a lathe/mill. There is a possibility I could use the uni one but I'm not sure. Do you think that would be the best course of action?
I'm a student and relatively new to kart engines but eager to learn.
I've just bought a 13.5hp Robin Suburu engine from ebay and am planning on fitting it to a Manco off road kart chassis.
My main issue is the unusual shaped crankshaft, it has a 1" diameter section that is 1" long before...