Recent content by trkk11

  1. T

    Honda GX270 charging system question

    Wow dude, thanks so much!
  2. T

    YerfDog identification

    Looks exactly like my 3202. Some asshat that had it before me cut off the bar over the engine, cut out the section behind the seat, and mounted the shocks to the ends of the cut off bar. I have my work cut out for me, but I'm pretty confident I can get it back to normal!
  3. T

    Torque converter questions

    What is the difference between 20/30/40 series?
  4. T

    Honda GX270 charging system question

    Anybody know where I can find the parts required for the 10a system?
  5. T

    Torque converter questions

    So, 6" driven would make less torque off the line, but higher top speed, and vise versa with the 7"?
  6. T

    Honda GX270 charging system question

    Anderkart, what is different between this and the 10A? Can I use the components in this kit and upgrade the charging coils? Or is the flywheel and everything different?
  7. T

    Torque converter questions

    Hey all, it's been a while. My Yerf Dog project got put on hold due to a few big expenses over the past year, but I'm trying to get back into it now...... I'm looking into putting a correct torque converter setup on it, but have no clue because a previous owner removed all of the torque...
  8. T

    Honda GX270 charging system question

    I saw that... what amperage is that going to charge at? I would think I'd need the 10A ---------- Post added at 01:54 AM ---------- Previous post was at 01:51 AM ---------- And any suggestions on a good battery to go on an off-road kart?
  9. T

    Honda GX270 charging system question

    I was just offered a running Honda GX270 for $100. I would like an engine with charging capability because I'd like to put a few LED spot lights on my kart build. The engine does not have a charging system now, nor is it an electric start engine. Is there a kit I can buy with everything I...
  10. T

    Looking for hubs for my new wheels

    I'm not really going to attempt this, but just curious as to what one would use to bore out a 1" diameter by 3-4" deep hole in a steel hub.
  11. T

    Looking for hubs for my new wheels

    Crazykart, if I were to try this myself with a drill press and a few hours of measuring, clamping, remeasuring, remounting, etc..... what type of bit would I use in my drill press??
  12. T

    Looking for hubs for my new wheels

    Now to find a machine shop! Would they be able to easily cut a keyway into it as well?
  13. T

    Looking for hubs for my new wheels

    The only hubs I have now are the 3/4 inch splined ones that came on the wheels. My original setup was wheels with the 1" keyed center hole.... I'd think any modifying of another sized hub with a drill press would quite possibly leave me with an unbalanced wobbly wheel.
  14. T

    Looking for hubs for my new wheels

    I just got new rear tires (20×10×8) from BMI..... They came with 4×110 wheels and 3/4" splined hubs. Does anyone know where I could find a couple of 4×110 hubs that will go onto a 1" keyed axle?? Just figured I'd try this route before going and buying another set of wheels. I bought them for...
  15. T

    Bushings?

    Thank you for your concern Denny, but I have filled out the location in my profile a couple of times and it still doesn't show up. I don't know why it isn't working, but I will go ahead and do it again. In case it doesn't work AGAIN, I live in New Lenox, IL, which is about 35 minutes southwest...
Top