Recent content by tribelwarrior

  1. T

    Clutch pre-engaging...

    It took about 4 hours to put the torque converter on and it was a very tight fit but now it can go get up to 35mph in a couple seconds. It can also haul over 500 lbs, off-road at 20mph. Also put a half quart of mobile 1 full synthetic extended performance 10w 30 in it.
  2. T

    Engine Bore Question???

    I would recommend this one... http://www.northerntool.com/shop/tools/product_200379207_200379207 But only because I'm in love with Kohler : )
  3. T

    Clutch pre-engaging...

    I thought I would post a quick update about my kart. I replaced the carb and that fixed the problem with it wanting to take off in idle. The problem was the other carb was dirty and would let enough gas in to keep it running on a lower idle setting. I also went and ordered a bullet lines torque...
  4. T

    Clutch pre-engaging...

    I might just do that then.
  5. T

    Clutch pre-engaging...

    So if I use the tav2, is there anything that I have to bolt or weld onto the frame?
  6. T

    Clutch pre-engaging...

    Every professional go kart website I looked at says I need a torque converter if I have larger than 15" tires. I love my tires so I think I'll just get a TC.
  7. T

    Clutch pre-engaging...

    Also If I were to get a torque converter, could I mount the driven right on the axle or do I have to used a jackshaft? Probably a dumb question...
  8. T

    Clutch pre-engaging...

    Btw I bought a brand new carb for 35 bucks so that will no longer be a problem.
  9. T

    Clutch pre-engaging...

    So I know I need to gear down, I used the calculator on hilliards website and it says for me to even use their centrifugal clutch I would have to lower my tire size to 10", raise my sprocket size to 72t and lower my clutch size to 8t. By the time I did all that I might as well go buy a torque...
  10. T

    Clutch pre-engaging...

    I would go buy a new clutch in a heartbeat if I knew it would fix the problem but I don't wanna waste the money if that isn't the problem.
  11. T

    Clutch pre-engaging...

    I let it run for about half a minute to warm up then revved it up a little and it started smoking.
  12. T

    Clutch pre-engaging...

    I'm just stumped... bout ready to just go get a torque converter.
  13. T

    Clutch pre-engaging...

    It starts fine on 1 pull and the wheels don't move when I pull it but once its on for a second or 2 it wants to take off.
  14. T

    Clutch pre-engaging...

    I loosened it just now and tried it for a few seconds but the wheels still spin.
  15. T

    Clutch pre-engaging...

    I didn't have to spin the axle, It was already spinning. But please don't say "That's because you overheated your clutch and ruined the springs so they engage too soon" because the wheels spun on idle before I ever heated the clutch up.
Top