Recent content by Stormn94

  1. S

    Bad Clutch?

    I'm pretty sure its not the ratio because it was working just fine... the clutch doesn't even begin to engage, which leads me to believe it has internal problems.
  2. S

    Bad Clutch?

    I am working on taking it apart right now, will let you all know what I find. Thanks for the suggestions.
  3. S

    Bad Clutch?

    Is there any way to stretch the spring somehow do you know?
  4. S

    Bad Clutch?

    This clutch has one continuous spring... how would i pull a couple coils wouldn't that make it tighter?
  5. S

    Bad Clutch?

    the spring does seem a bit tight... do you know how i can adjust it?
  6. S

    Bad Clutch?

    It doesn't even heat up, which really surprises me.
  7. S

    Bad Clutch?

    I have a Briggs and Stratton engine I think it is around 5 hp. Then mounted on it I have a centrifugal clutch... When the engine gains rpm and the clutch has sufficient speed to engage, it won't engage. It is a fairly new clutch. anyone know whats wrong? thanks all, Nik
  8. S

    Hello and My First Question

    The cylinder is somewhat scraped up but I think it would still work. I found a used engine on Craigslist for real cheap and it runs good so I solved that problem. Thanks for the advice though.
  9. S

    Hello and My First Question

    Ok, so one of the rings on my piston snapped. Now I think I will probably just be getting a new engine. But thanks for all your help everybody I'll let you know how this turns out -Nik
  10. S

    Hello and My First Question

    The gasket is slightly hardened but is still pliable.
  11. S

    Hello and My First Question

    The carb has a gasket where it attaches to the engine so i don't think its leaking there. I will try to clean the jets tho. Thanks
  12. S

    Wanted: GoKart Wheels

    Hi, I need some new rear wheels for my go-kart. I would need 2 that have a 6 inch diameter or less, and that fit on a 3/4inch D-shaft axle. Looking for something pretty cheap. Let me know if you might have something. Thanks, Nik
  13. S

    Messed up Idle

    Thanks I'll try that and let you know how it works.
  14. S

    Messed up Idle

    Hello, I have a go kart engine and it won't idle right. I've tried adjusting it using the idle screw but that doesn't help, anyone know what I should try next? Thanks, Nik
  15. S

    Hello and My First Question

    Thanks for replying... First of all, it is an old engine. I did clean out the carbeurator very well and I did notice a difference in how the engine ran but it did not affect the idle. Thanks.
Top