Sparkwizard's latest activity

Like this.

He’ll only run it out of gas or oil one time before he learns to check it on his own.

Maybe drill a hole in the top and bottom, install a sight glass. Clear vinyl tubing is cheap and easy to install. Two hose barbs, a dab...

I do not think cutting tie rods is going to get you where you need to be. You will need to cut and reweld that rack and the housing...

Does it not have the governor? I'm confused, so I ask... How can the carb act as the throttle stop when there is a long spring between...

While we are talking about wide open throttle, check your governor arm. The one connected to the round shaft coming out of the engine...

I'm with Jim. I think they shipped you the next size bigger belt by accident. Do you have the belt oriented properly? Almost looks like...

Several checks you can do for starters. Drive around for 5 minutes WITHOUT TOUCHING THE BRAKE, just coast to a stop. Now get out and...

Sounds like a good plan, and I agree that I would do that first, too.

Spark, Thanks for that. I'm first going to try the old cut off wheel and welding method. All I have to do is shorten one (?) tie rod...

Master Hack said exactly what I was going to say. Just put a U-joint in the shaft and angle the steering column to the center. If you...

https://www.gopowersports.com/steering-knuckle-cheetah-blazer-200/ https://www.gopowersports.com/go-kart-steering-kit-complete/...

They make different size belts. Unless you bought a genuine comet TC the belt will only last a few minutes. There is a specific brand...

Thanks. The Nibbi has a straight pull up knob. I found a complete pre made cable kit for the Nibbi with the screw on cap, cable, and...

Damn dude! Yer getting purdy old for that shyt. Old men heal a lot slower.... If ya can't even get out of the dealers place, doesn't...