Recent content by Snuffalupagus

  1. S

    Yerfdog 42101 Carb help

    Toystory, you comment about adjustment got me thinking. So, I went out today and took off the carb. I adjusted the tab that holds the needle, bending it upwards a smidgeon. My daughter drove the kart for about an hour with no problems. I never, ever, thought I would need to adjust the float...
  2. S

    Yerfdog 42101 Carb help

    Thanks everyone for your tips. I'm going to pull the carb off again tomorrow and see what I can do. What's really getting my goat is how it happened on the old carb before and after the rebuild, and on the new one too. Time for a Mikuni. :cheers2:
  3. S

    Yerfdog 42101 Carb help

    No, sir. No pump. It's gravity fed. Today I connected the fuel line and before I could start it, fuel came out from the overflow. I don't know why the float is sticking on a brand new carburetor. :huh::confused:
  4. S

    Yerfdog 42101 Carb help

    No suggestions? :surrender:
  5. S

    Yerfdog 42101 Carb help

    It's the 150cc Howhit on a Yerfdog 42101. I did remove the bowl from the new carb thinking the float was taped in place or something for shipping, but it wasn't. We tried it again yesterday. It started right up, idled for 5 minutes with no problems. When my daughter took it out, it ran for...
  6. S

    Yerfdog 42101 Carb help

    Before I torch this thing... :furious2: Problem: Fuel pouring from overflow vent. Precursor: Engine starts great, runs great. After 5 minutes or 30 minutes running (depending on its mood), fuel comes out of the overflow. Preemptive strike: Rebuilt old carb with new float, needle and seat...
  7. S

    yerrf dog flouds after its riden everytime??

    That's what is frustrating me. I just rebuilt a 1962 Code 38P Pontiac 389 v8, but I can't get this little Japanese carburetor to work right! I've cleaned everything. Today I thought I'd give it another try. Took of the carb, double checked the float for leaks, inspected the new needle and...
  8. S

    yerrf dog flouds after its riden everytime??

    Hey guys, I'm new here and found this forum and subsequent thread. I'm having the same problem with my 150 yerfdog. I have replaced the needle, seat, and float. It starts and runs fine for about 5 minutes, then it acts as if the float is stuck, and fuel flows from the overflow. I am about to...
Top