Recent content by s0me1namedkyler

um all i ordered was a "standard kit" so it was probably ok

idk just felt like i guess. yes rings were replaced

replaced piston, air filter, muffler, spark plug i guess you wouldnt call that a rebuild lol

they're identical

hey everybody. just did a rebuild of my engine and its completely cleaned out and has brand new oil. but when i run it, it really starts to stink bad. is this normal or should i just deal with it?

Correct. usually there a 10-12 teeth on the clutch, and 60-72 on the axle sprocket.

the clutch you will need will be a 3/4 inch centrifugal clutch (if you arent using a torque converter). a centrifugal clutch activates at a certain rpm. don't use a sprocket directly on the shaft because then the cart will be constantly moving when its idling.

how hard would this be to build? (or something similar) http://www.goped.com/products/goquad/default.asp

i dont need the belt drive or whatever its called, but its rusted on there really good, tried wd40 and didnt work. suggestions?

lol i found out it was from a hedge trimmer... so its not going to be very powerful then

i have a couple questions. got a chainsaw engine from a friend that didn't use it and decided to put it on my mountain bike. what is the best way to mount it on the frame? and what is the best friction drive method? thanks

where could i find honda clones?

thanks for all the help guys. i was thinking of putting on a 3 hp briggs. do you think that's powerful enough?

hey. what do you think about this go kart? http://www.northerntool.com/webapp/wcs/stores/servlet/product_6970_200356855_200356855

sorry, which of these points would you hook the throttle to?