Recent content by RToth

Up and running! The driven clutch is still not perfect but I put a thin spacer behind the snap ring to make up for the worn snap ring groove, drove it all over today without issue :)

That is my thought exactly, just throw a spacer in there, there should have been one there to begin with!

Thanks Dave! Any work done to the kart or all stock stuff? I think I also have a wrist pin rattle on my engine, but I have an old John Deere 214 with a good engine on it I may try to throw on here :cheers2: firemanjim, I looked at my jackshaft assembly and the bearing towards the clutch has...

That's pretty cool!

I actually had a Chevy 305 V8 blow a hole through the block completely exposing the crank case, I have video of it still running! It didn't run very good, but it was able to fire up lol

Took a lot of redneck ingenuity to get it where it is so far, I hated working on a dirt driveway with no garage or anything! Much happier now with a paved driveway and a garage :)

Little JB Weld and some duct tape and she'll be good as new!

Already found the build thread, I will be following for sure! Here is the thread for my Bonneville, yup... it's a FWD granny car lol http://www.pontiacbonnevilleclub.com/forum/your-ride-pics-and-videos/topic42640.html

Getting work done on a build always puts you in a good mood, I know very much how that goes, I have put an insane amount of work into my Bonneville and plan for a ton more yet. It is a great project / daily driver! I can't find a used / OEM complete cover, but I do see a lot of recoil...

How much for the shroud? I hate the wrap a rope, my friend told me that the recoil dogs were about shot and he only ran it a few times (bought two broken ones, one to fix and keep, the other to fix and sell) I got it and the dogs broke after two pulls. I think it is the original Tecumseh...

Thank you! I will go and fill out my stuff shortly :) :cheers2: Here is a few pics of it from last summer when it was working good. My two boys have a blast with it! If I take the roll cage off it fits quite nicely in my Suburban too! Tomorrow I will post up a couple pics of the damage.

Picked up this go kart from a friend that bought new parts for it but never got around to putting it back together. I got it all assembled and we were able to play around with it for a year or so, then the driven clutch sort of came apart. What it looks like to me is that the snap ring groove...

Found this place doing some searching around for my Yerf Dog 3203 I bought off a friend, looking for some advice for the jack shaft bearings and driven clutch. I will probably be around here on and off, I am always wrenching on stuff, usually cars, but I like playing with anything that has an...