Recent content by rootcory

No. They were the ones that came. On my cart it is a maxxam 150r with a 500cc sled engine

So does. Anyone have a good source for aluminum wheels? I snapped the centers out of my thin steel wheels!!!!!

Won't it get the heads to hot if its to restrictive And it is a two cylinder

I have it installed on the kart now but i have nothing to compare it to?

Any ideas?

I know that but that will be tough to find as this motor is out of. An old arctic cat

re I cut it right at the seam an rotated it and welded it back together so it would rap around the motor

So I needed an expansion chamber for my motor on my cart so a buddy of mine had a pipe off of a yamaha blaster 250cc quad so I cut it. And clicked it to fit where I needed it to fit Am I hurting the performance of my motor? By running this pipe?

I ordered what I did because I was told by a member on here to add the tth3 4.5 and 4.5 together not multiply them ! 8000 rpm 22 inch tires The cvt is 1 to 1 I would like it to be snappy in the low end with a top speed around 50 to 60? Right now. It pops wheelies!!!!

So how do I figure out the sprockets I need? I really don't want to change my axle sprocket it is a 45t now and I just got it custom made NOT CHEAP

huh so now what cause its already built? So what should I b running?

Ok so I'm building a full suspension cart and I'm a little messed up on gearing The Kart is a carter hammerhead style two seater the engine is a 500 cc arctic cat fan cooled I decided to go with a twin jackshaft setup with a 10t to a 45 t and another 10t to a 45t sprocket on the axle...

It was a headache at first but now I'm collecting all the parts I need for a double jackshaft setup

no love huh

Hey Guys Im new here been building jeeps and cars for along time along with quads and dirtbikes ETC... So the other day i picked up a one wheel peel gokart with a 5 hp tecumseh on the back built a new axle for the back cause the old one was bent and threw some new bearings in it and so...