Recent content by Rocket99

Cover off Does this help cover off

Could I use a centrifugal clutch rather then a torque converter?

So looks like it's 1:1 I put a marks on the output shaft and the part where the pull start connects and did one full revolution and they both lined back up and they both did one revolution. ---------- Post added at 06:29 PM ---------- Previous post was at 06:28 PM ---------- What does this...

How do I know if it is a 2:1 reduction or something else?

How about this one?

What about this one?

How would I set up a manual clutch?

Would this fit?

Do these pictures help? Maybe it does not have a 6:1 Maybe it's a 2:1 in not sure. It has plenty of power it just needs a clutch. Thanks

Right now have to push start it. If I lift the back wheels off the ground I can pull start it. When running the wheel continually turn so only way to stop it is to turn the engine off. It goes pretty quick though does about 60kph. Thanks

That it thanks ---------- Post added at 11:27 PM ---------- Previous post was at 11:22 PM ---------- Any ideas how to put a centrifugal clutch on it?

The leaver goes down into the crankshaft somewhere

Here is some more pictures. Anyone know what the lever on the top of motor Is? Circled in blue. Thanks

Are these Ok?

Maybe it is not a 6:1 because I put it in direct drive without a clutch and it was pretty quick. It has some sort of reduction box on it.