Recent content by rman

  1. R

    Doodlebug 212cc Gearing / Torque Converter help

    thanks. looks like I need a significantly smaller rear sprocket than I thought Sent from my HTC One_M8 using Tapatalk
  2. R

    Doodlebug 212cc Gearing / Torque Converter help

    what engine? any idea as to top speed? Sent from my HTC One_M8 using Tapatalk
  3. R

    Doodlebug 212cc Gearing / Torque Converter help

    Hey all, Have a DB30 with a predator 212cc; jetted, filter and straight pipe. Governor removed, stock valve springs, maxing out at 5300rpm @ 37mph (12t/72t) Want to go down to a 60t rear sprocket, then I got to reading about torque convertors. It's my understanding they help with both...
  4. R

    First Post - Predator 212cc won't start!

    based on the online calculators, it should give me another 7 (44mph). plus it should help keep the front end on the ground. in the future, I'd love to upgrade the valve springs, flywheel and rod, and throw a torque converter on it. But for the time being we reigning with budget! just found a...
  5. R

    First Post - Predator 212cc won't start!

    messed around with a gearing calculator, and determined that my engine was running 5300rpm before (and after) the governor removal Sent from my HTC One_M8 using Tapatalk
  6. R

    First Post - Predator 212cc won't start!

    my gearing won't surpass 37mph at my max rpm which is odd since my max rpm did not change after removing the governor Sent from my HTC One_M8 using Tapatalk
  7. R

    First Post - Predator 212cc won't start!

    eventually I will. I am an inexperienced rider (bought my kids some monster moto minibikes for their bday 2 weeks ago, I was instantly hooked). I've laid this minibike down more times than I'd like to admit, it stands up at just a slight crack of the throttle. The other day it actually lifted...
  8. R

    First Post - Predator 212cc won't start!

    the tension one? I actually just tightened it down, that was my idle problem. Was too loose and idle was set in an unnatural postion (plate overlapped a stop). tightened that, backed out my idle screw, and re-bent my linkage (was a good 1/4" too long). as far as the throttle limiter screw...
  9. R

    First Post - Predator 212cc won't start!

    thanks guys, it was a quick fix, both pushrods were out. got them in place and took a quick test drive. I'm still topping out at 37mph (#35 12t clutch, 72t rear sprocket). Exact same speed, seems to bounce off "a limiter" a lot more (stock valve springs). also need to adjust my throttle...
  10. R

    First Post - Predator 212cc won't start!

    a lifter did fall out and i just popped it back in. That would explain the lack of compression "sound" when pulling the starter Sent from my HTC One_M8 using Tapatalk
  11. R

    First Post - Predator 212cc won't start!

    Hey all - First post here! Too bad it's a help me post! Anyhow, put a Predator 212 in my doodlebug last saturday, clocked it at 37 max before bouncing off the governor. .038 Jet, emulsion tube and pilot jet. air cleaner straight pipe header So today, I rip it open and take the governor out...
Top