What is everyones preference on piston rings for gx 160/200 and clone engines. I have used cheaper ebay ones that come with the waffle style oil rings, and OEM sets that have a single peice more heavy duty appearing oil ring. The oem ones always seem to have an engine with less blow by and...
In theory it would be possible, but the clutch bolts in through threads on the end of the shaft so it would need to be tapped or something aswell.
My research has basically yielded that the gx models that utilize the 1/2 wet redux clutch are RH models, and the main difference is a slightly...
on a clone or gx200 /160 what constitutes using a heavier valve spring than the stock 10.8. if the gov is still attached is anything heavier necessary. at what point in the modding process is a 18 lb, or 26 lb spring necessary/recommended
this is the variation between cranks. the stock one is the shorter one and thats what i need, on my stock gx160 cranks there is a number stamped on them and they all start w AG S .........
ya i was hoping to make a deal w/ harbor freight to endorse and only run their engines with a stage 1 or 2 kit and save some $ and a get a deal, Has anyone here succesfully put a 1/2 reduction clutch on an engine that isnt a honda? Im very familair w/ the stock engines, but new to modding the...
ok so long story short im in charge of a small fleet of 5.5 and 6.5 honda gx's at a small rec track. I run them w/ the 1/2 reduction wet clutch on a belt driven kart, thats how they were setup when i became responsible for them. I have taught myself to rebuild them reliably but im by no means...
they are used engines from a recreation kart track, so they have probably seen a couple years of abuse. a couple of the cranks n rods have some prominent frictions marks, and some of the blocks have been run to the point where honing seems pointless, they look as if the sleeve is worn in spots...
So i have a couple honda gx160s and gx200s with 1/2 wet reduction clutches. I was running into the issue where the cylinders and crankshafts were beginning to become worn out. I bought a clone engine on ebay, but the crankshaft is too long to allow clutch to fit properly. Do the 1/2 reduction...