Recent content by r1ng3l78

  1. R

    13hp blue clone won't idle below 57degrees

    yeah it's brand new. it has a mixture adjustment and that's it. it was in the 60's today so i was using it to drag brush around the house.
  2. R

    13hp blue clone won't idle below 57degrees

    like the title says, if it's above 57 degrees F, it fires and runs fine. below that, it's start fine on full choke and idle for a couple minutes half choked but open the choke or give it any throttle and it starts to pulse, dies, and won't start again for about 15 minutes. i was going to...
  3. R

    kart nearly done

    forgot i had uploaded some pics already and some things have been changed since these were taken. and they're huge so sorry if your dial up.
  4. R

    kart nearly done

    right now it sits at 2 degrees positive with no load and with a 200lbs rider on it it's at 6 degrees negative. that's about halfway thru the travel of the shocks. the steering is a little tight on pavement but it's much better on dirt. the trick i've found with single A arms is they want to...
  5. R

    kart nearly done

    well, i've tweaked the front suspension (since i was doing something stupid and broke it) and got the camber where i like it. clocked it at 32mph which is what it was supposed to top out at and now it's time to tear it down and do the final weld and assembly...
  6. R

    kart nearly done

    problem is i don't want the camber to go very positive since this is a yard kart because that could make for a bad landing if the front end unloaded. also it wasn't designed to haul 500lbs of sprung weight. with 200lbs on it, it's not so bad but still needs an adjustment. i'm doing this for...
  7. R

    kart nearly done

    i had posted back in december about a kart i was building for school that was to be able to pull a trailer around a farm with about 200lbs of cargo in it. there was quite a bit of contention as to whether or not the tc2 converter i paired with a 13hp clone would hold up to 400lbs of driver and...
Top