I purchased a go cart back in October and got it fixed up thanks to this awesome forum, but one of the two sides of the torque converter flew off about a month ago (Finals kept me busy). Its all scattered in the grass except for some larger pieces and the belt which isn't pictured. I don't know...
its lossened alreadys. its about the springs not being balanced. i dont know where to hook them up.
---------- Post added at 04:35 PM ---------- Previous post was at 04:33 PM ----------
also, what are you supposed to do with the spring wrapped around the throttle column
On a predator 212, when i start the engine, it instantly revvs way too high. I think this is because the throttle springs arent strong enough. Im not sure of the way they should be connected, and am wondering if anyone has any pictures of how it should be set up. keep in mind when i got the go...
I got the parts
I got some older engine chunks off a guy, and have all the parts to replace it. I put the carburetor shaft in, but I don't really know how to link up the governor? Whats everything g do? What parts go where? Is there a tutorial?
So,the lever is actually there. There are still two springs that aren't attached to much. Would I hook those back up to the prospective throttle assembly?
so, i would need the following three parts:
http://www.bmikarts.com/Pulling-Rod-for-65-HP-Clone-GX-160-or-GX200-Engine_p_109.html
http://www.bmikarts.com/Throttle-Control-Assembly-for-Honda-GX160-GX200-Clone-55-65-HP-Engine_p_2538.html...
so, would that be the thing that hooks into the black part? would it just fit and bolt into the rest of the engine? also the black column looked somewhat damaged, im not sure that the hook rod thing would hold. ill post a pic
I purchased a go kart off craigslist around 1 week ago, and now, the throttle cabling tore, a cheap little piece of wiring. I ordered a new heavy duty one, and attached the front. On the back, however, there is no place to attach it to the little throttle column thing(this was where it ripped...