Recent content by NewDingo85

Im located in Auburn Alabama and I agree that everything and anything with a motor is a toy. So if the pictures weren't BA enough....the Mitsu is a right hand drive too? Man you Freaks really know how to get down lol.

Holy $*%# ive finally found another Minitrucker on here haha. Once I spotted the Mitsu in the side of that picture I just about fell out. Truck looks sick by the way....im working on a x-cab yota right now. Ive got some friends down here that are also in Freaks...good people. The kart is...

Good with Computers huh? What do you do for a living if you don't mind me asking. I'm in IT as well.

Thank you I appreciate it! I learned alot on this one so im excited to see what my next one will turn out like.

HaHa I like the "sleeper" image and if I keep going the way I am now I'll wind up with a fleet myself lol. I cant wait to tear this one back down so I can get some paint on it.

It would have difficult to say the least. I greatly appreciate all the help that I've received here and I hope that I can give back some of what I've learned. Thanks again everybody!

Haven't hit any mud yet...I've trailed it mostly.

Thank you and again I appreciate the help. :cheers2:

So I got it all put back together and rode it a little bit. I was really worried that the bigger tires were going to make it drag off the start but I was pleasantly surprised. This thing runs like a scalded dog. I still have to rebend the roll cage bars, fix a few odds and ends, and paint it...

I got the Stage 1 Hop-Up kit from NR and got the motor installed. I didnt, however, install the entire kit just yet. I put on the open air filter adapter and filter, changed out the jet, and installed the header. Once I get the motor broke in ill go back and install the smaller fan, timing key...

When the rear hubs came in I test fit them onto the rear axle and noticed the the back of the roll cage that goes around the bottom of the seat was going to hit the tires. I took the tires back off and realized if I cut the 90 degree bend and flipped it that it would give me just enough room to...

I wound up having to cut the hubs on the front tires down to make them fit but thanks to Sinbad001 again for letting me know this ahead of time. It was really easy....just took some measurements and made the cuts with a die grinder. Cleaned up the burs with a file and reinstalled the bearings...

So when I started this build I decided that I was going to need some nice size tires to hold me up. Im 6'2" and about 200 lbs. So after seeing another thread on here and picking the brain of fellow member Sinbad001 I decided to go with 20" mini bike tires from BMI and set of 22" Badlands that I...

Ok so I got the A-Arm in and welded up without any problems. You can buy these already welded up but im a welder by trade and enjoy it so I ordered them raw. Here's a few pics of the new A-arm next to the old one. Its hard to tell from these angles but it was bent up pretty bad.

Ok so I figured it was time to start a build thread on my yerf dog. I picked this up a couple months ago and have been working on it here and there. It is a 30032 and was in decent shape when I got it. My plans were to slap on a Predator 212 with some goodies, 20" tires in the front and 22"...