Recent content by nealolsen

I just drilled and tapped a 1/4 bolt. You guys were right it was easy.

Would a 5/16 bolt be good enough, with the key way there isn't a lot of thickness left.

Is there a 5/8 clutch with a set screw? My briggs 2hp has a straight shaft and is not threaded to use a bolt to hold on the clutch. Any help would be great already ordered on and there was no place for a set screw.

Thanks for the help.

Im going to leave the governor off when i put it back together. How much do these motors wind up? I don't want to blow it up.

I'm building it for my sons mini bike. I picked it up for $20 bucks not running along with a 1967 2hp not running. ---------- Post added at 11:01 AM ---------- Previous post was at 10:59 AM ---------- I appreciated the help and info.

Im trying to figure out what size briggs I have. It was on a Montgomery Ward edger but the shroud has no numbers on it and the edger model is zmy 161c I think some is scratched out. The block is aluminum, 8 bolt head and it has points. The bore is measured at around 2.371 and stroke is 1.5. I...