Recent content by Mikez3202

Would you just sell the kohler?

How long is the 3/4 shaft?

You have any carbs?

Woops I did not realize that, thanks for the heads up ill be sure to look closer next time.

What kind of cams are those?

Hey everyone I am in need of a dyno 458 cam. I'm from CT and I'm willing to pay around $50. Thanks.

Hey everyone I'm looking to build my briggs raptor engine and make some good hp. It's pretty fast now but I want to make it faster. I'm looking into a dyno 458 cam. I want to know what mods I will need to do to the block to make this work. Thanks in advance.

Yea the spring is tweaked pretty bad but I rewound it the best I could. Just took it out for a few laps around the yard and it works just fine. I ordered a new spring just to be safe.

Thank you very much, after looking closer I did make an error I didn't put the retaining clip on all the way thus making the 2 plates separate enough to loosen the spring and cause it to fail.

Managed to get some photos up

Hey everyone I have a yerf dog 3202 kart with a briggs raptor racing engine and I use a comet 30 series clutch with a torque converter. This afternoon I was running it around the yard and I was messing with the settings on the driven unit and set it to 1. After doing this I went around the yard...