Recent content by Lph008

Lol tried that and torch

Can't even get wheel hubs to break loose,

Can't get axle out, anyone have any pointers?

I can get the axle out, not sure of I'm Missing something?

Is there a way to put new sprocket and collar on without removing axle? I know I can get two piece sprocket but what about the collar that holds sprocket in place? Just lookin to get her goin to sell

I'm getting it going to sell, work My way up to a racer. Can't even get the axle out lol. I'm trying to cuz I need to put new sprocket on

Does anyone know the make/model of this kart? I need parts for it, need to know how to get axle out also, not sure how it comes out, how do wheel hubs come off?

Ok so I can't figure out how to get the collar off that my sprocket mounts to, there was one screw in it, I took it out and no luck! I'm trying to upload pictures of it http://i1168.photobucket.com/albums/r492/liam5340/C99F3630-405B-4B3C-B9AB-266684569A08-4181-000003D77685D5AB_zpsf1cacaab.jpg

Ok I see, so where should I buy sprocket and chain cheap? Not sure what's a good price

Are there different sized bores for sprockets? And where do you guys buy your sprockets and chains? Looking for 60T or 72T for my kart, not a racer just a yard beater.

Im using a centrifugal clutch was told to get a 10t sprocket clutch and a 72T sprocket for axle...

I'm Also in the same boat trying to figure out sprocket sizes, also ground clearance. Gonna run a motor between 5hp and 6.5hp would like it to be quick off the start but also have good top speed, the kart I got had a small engine and a 16T shaft sprocket and 30T axel sprocket on it, I've been...

Sounds good guys, thanks for all the helpful info! I'm sure I'll be back lol

Ok dumb question, do I buy the chain cut to length or can I buy it now? Would like to order clutch, sprocket and chain today and get motor over weekend

No I actually have to buy a sprocket and clutch, the sprocket that was on the axle was only 30T, so that's why I needed to know what size sprocket and clutch, does it matter if I get a 3/8 or 1/2" pitch sprocket?