Recent content by Lawes12

  1. L

    Eating up belts

    Ok thanks again! ---------- Post added at 09:40 AM ---------- Previous post was at 09:37 AM ---------- If I were to go a ratio of 7.5:1 with smaller tires would that help or no? The problem with going bigger axle sprocket is finding one big enough and clearance issues. ---------- Post added...
  2. L

    Eating up belts

    Fairly new build I have a 8 tooth driven sprocket and a 48 tooth axle sprocket so a 6:1 gear ratio with 20 inch tires on a two seater go cart with a knockoff tav 2 torque converter.
  3. L

    Eating up belts

    My torque converter is eating up belts fast! I was wondering if a way too tight of a chain will cause this? Any other suggestions?
  4. L

    Torque converter

    Thanks I am running a knockoff tav.2 and I am running a 6 :1 ratio. I am not sure if I have the holes or not I will check in the am will it be on the inside part or the outside?
  5. L

    Torque converter

    I was wondering if there is any way to make adjustments to my torque converter for more bottom end power?
  6. L

    Roller chain

    I am ordering a new sprocket and I have a #40 chain will a #41 sprocket work well with a #40 chain?
  7. L

    First go cart

    I just noticed that my brand new belt is a little tore up? Is that from improper gearing or?
  8. L

    Engine mods

    What does everyone think of this set up a LCT 291 cc with govenor removed main carb jet increased to 90, less restrictive intake and exhaust. Do you guys think I need to switch out valve springs to 18 lbs because I removed govenor or no?
  9. L

    First go cart

    Sorry not 64 tooth 54 tooth my bad
  10. L

    First go cart

    So I have decided to run a 8 tooth drive sprocket with a 64 tooth sprocket. I think the ratio should be around 6.75:1. What do you all think? I had my wife drive it she is maybe 130 pounds and it took off like a banshee with her and my girls in it so maybe around 200pounds plus cart I think if I...
  11. L

    First go cart

    Do you know any place that has intake and exhaust for my engine? What do you recommend
  12. L

    First go cart

    Pic 3
  13. L

    First go cart

    Pic 2
  14. L

    First go cart

    Pic 1
  15. L

    First go cart

    Ok do I have to upgrade anything internal in order to remove the govenor?
Top