Recent content by Kidthatsirish

Also, I forgot to mention, the engine this will mount to is a honda gx25, a 1 HP engine I think. Will that cause problems?

Agreed, do you have any advice or tips on doing a modification like this? I imagine if I don't find a way to properly match the ratio of output shaft speed to axle speed I could seriously change the speed and power available to the go karts.

Thanks for the advice. I looked up the torque converter assemblies you mentioned. As I'm sure you realize they look nothing like the reduction gear assembly with sprocket that attaches to the chain that wraps the sprocket on the axle. I assume you are suggesting a retrofit or some sort?

Ok,...so doing a little more research turns out these are go karts that where made by liberty and they went under. They turned over the parts to tomberline who I'm told does not have the best customer service. The engines start fine. But these center dry clutches/reduction gear assemblies get...

Sorry folks... Still figuring out the webpage.

Next pic

Here are more photos.

Hey folks,. I have a couple questions. I have two hot wheels go karts. They have paddle style break and gas. There are four stroke honda engines that power them. My issue is that the clutch (for lack of a better term) seems to have eaten itself. It's a metal housing that bolts to the engine...