Recent content by KasalmoR

That looks pretty nice!:thumbsup: Can you post some close detail pictures of it? I would also want to ask how much degrees camber you made it? I am trying to figure out right camber angle for single A-arm setup and I will be glad if you could share some info.

Yes. What I mean is if you don't have problem with the look you can leave it that way. There will be no harm if welds are not smooth.

One question- Is it necessary that you grind off the welds? I think they wont be a problem as long as it is not leaking. Just put some primer or paint so they do not rust and use it that way. Am I wrong?

Even though I have no actual experience with this site I had with one which looks pretty similar called Alibaba.com Both sites look almost the same and have similar listings. The problem is that I had the worst internet purchasing experience in the site I mentioned. I found out the hard way that...

What happened? You bought it?

I don't have an actual story behind my nickname but I just want to join in the thread. This nick came to me may be 5-6 years ago when I just wanted something different that will be unique. I just came with some variantions of a word similar to that nickname and I chose that one. I have been...

Hey that looks nice. Can you upload larger and more detailed pictures of it after you have bought it. I will be glad to see more indept view because I have a similar construction in my mind so I can compare it to that and figure out some issues I met with my design. Thanks, Kristian.

I may be retarded but I can't figure out how to get them even when they are free. Any help? I downloaded the free sample .pdf but I don't know how to get these.

Here are two examples of possible construction of the suspension. In the second picture I made it so the camber can be adjustable. I'm not sure it will be sturdy enough but it can be adjusted. The other alternative the camber will be fixed and I think that the inner side of the tires will wear more.

Thank you for the info and if I got you right you mean that the tie rods must be parallel to the A arms, right? So they will travel in the same way when suspention works. That's one pretty nice looking kart. I like the construction and the paint you chose but I cannot understand why you use...

One part because I'm not really familiar with single A arm setup. I think that when single A arms are used the bracket for the spindle is welded onto the A arm right? And it stays on it at a particular angle but when the A arm moves up and down the wheel will tilt from being straight up to the...

So as I said here is what I have in mind. The first alternative a kart with rear suspention only : http://img88.imageshack.us/f/dsc03071m.jpg/ The other alternative, I added a front suspention with double A-arms. So here's the frame : http://img135.imageshack.us/f/dsc03069g.jpg/ Now I have...

Can you suggest thickness? I am asking because I saw measures in another thread but they were in gauges? (don't know that) So I will be glad if you can tell me in mm (milimetres) that would be best. Thank you in advance! Now I am thinking on a version of the kart with front suspention and the...

I can't remember exactly which comment was yours but if it was about the fabricating skills as well as tools i have provided I will anwser again. So partly this project is for me to learn basic skills and to try out if I can desing a good vehicle. I am learning how to weld with MIG (The one...

(Relisting the thread using google cached version) Hello, everyone! I have been browsing the forum for a few weeks now and I will try to start my own thread. I really like the community and I think that there are many erudite people around here that will be glad to help. So after having said...