Recent content by kahnbiraj

This is exactly what i am talking about. How do I base the selection of joint type based on what forces act on the frame? And I added the 'engineering' bit so that someone could explain me the engineering on which the selection is based.:)

Okay. So I started cutting the links for my frame. And there are basically these two ways to go. One is to cut straight links and weld them at the perpendicular joints. Other is to cut both at a 45 degree angle and weld them. Since I will be following either of these ways all along,Please...

I have a 1 inch steel shaft that I can thread at the ends . I plan to use as the axle. It's a solid shaft. I have another hollow shaft of the same diameter(outer). Actually, can you please suggest which one should I use for the rear axle? I guess hollow would do for the front ones. But do I need...

Okay. How do I start out now? I saw that the wheels are rated as 6'' or 10''. I guess those are the wheel diameters. How do I check if the wheels are good for the axle I want to use?

Lol ! How did I do that? Sorry if anything went wrong. I am new at this. And you said the information is 'there'. Where, please?

Greetings from Nepal! I am new to building go-karts. I started designing my steering, the chassis and worked out few other parts. However, I am a bit confused with the wheels. Everywhere I see, the wheels and the tires come separately. Is that the case? Or do we get to buy the whole assembly? Or...

Wheels? I am new to building go-karts. I started designing my steering, the chassis and worked out few other parts. However, I am a bit confuses with the wheels. Everywhere I see, the wheels and the tires come separately. Is that the case? Or do we get to buy the whole assembly? Or am I...