Recent content by JBkartman

  1. J

    New here need help

    The frame is lower to the ground in the front and goes up in the back..... As u can see the added frame going up in the back on a angle.
  2. J

    New here need help

    Here's some pics These are updated pics. The belt could be the next step smaller because it takes a second for it to catch and top speed could be better with one, but its temporary. Going tomorrow to take it to the shop to weld a few reinforcements and some support to the frame. Also debating...
  3. J

    New here need help

    Thanks on the setup. Does it matter which way the torque converter driven is put on . weather the spring is facing inward or out?
  4. J

    New here need help

    Thanks everyone and for the duck! got the driver set up just waiting on the sprocket and longer jackshaft I ordered.do you know how you set up your throttle?
  5. J

    New here need help

    Thanks for the tips. Another questions do I order the 203443A item number torque converter belt for these dimensions? If im measuring correctly.
  6. J

    New here need help

    is this supposed to be like this? Are you suppose to just put the screw on to hold in place like this?
  7. J

    New here need help

    What about 12 inch
  8. J

    New here need help

    58 I believe
  9. J

    New here need help

    ^ *wrong one http://www.bmikarts.com/item/41-Sprocket-400902--3313 10-14 tooth
  10. J

    New here need help

    thanks everyone I am ordering all the parts tomorrow. Which number sprocket should I buy with the #41. 8-17 tooth ? http://www.bmikarts.com/item/41-Sprocket-400901--1507
  11. J

    New here need help

    It should I emailed them. So all I would need is a 3/4 jackshaft and a sprocket. How does the driven torque converter stay on the jackshaft without moving.
  12. J

    New here need help

    thanks anderkart if that bracket works then thats probably the route id go with because it doesnt require much lol. Do you think the distance from the drive and driven will be at a far enough distance?
  13. J

    New here need help

    That looks like a good idea but i would have to weld a bracket to mount those. Check this out http://www.diygokarts.com/vb/showthread.php?t=12946
  14. J

    New here need help

    how would you mount the pillow block bearings though on my kart? I would say those would be a good idea but complicated to mount and making sure it lines up. decisions decisions :huh::stir:
  15. J

    New here need help

    I have found this but do you think the engine would bolt up to it and work with the 3/4 40 serious http://www.bmikarts.com/item/Motor-Mount-Plate-with-Jackshaft-and-Bearings-400361-6636
Top